|
Hydrogel Mold Compound & Platsil Gel 10
Hydrogel Mold Compound & Platsil Gel 10
Using the Hydrogel Mold Compound to make a mold of a hand. Then cast the Platsil Gel 10 with fleshtone pigment into the Hydrogel mold to create a life-like casting
[...]
|
|
GELNIQUE Gel 10% - Approved by FDA for the Treatment of OAB
GELNIQUE Gel 10% - Approved by FDA for the Treatment of OAB
For more info on this and other stories, visit www.newsinfusion.com Corona, CA, January 27, 2009 – Watson Pharmaceuticals, Inc. (NYSE: WPI), a leader in generic and specialty branded pharmaceuticals, announced [...]
|
|
Mold Making Lifecasting Technique: Gel-10 Body Cast
Mold Making Lifecasting Technique: Gel-10 Body Cast
Here's an overview of a lifecast taken with Gel-10 and supported with plaster bandages.
From:
brickintheyard
Views:
39817
[...]
|
|
Mold Making Technique: 1 piece mold with Gel-10
Mold Making Technique: 1 piece mold with Gel-10
Great mold making method for seamless head molds using Gel-10. See the follow up video to see resin cast in this mold.
From:
brickintheyard
Views: [...]
|
|
Mold Making Tip: Gel-10 softened with Silicone Fluid
Mold Making Tip: Gel-10 softened with Silicone Fluid
Softening Platsil Gel-10 with silicone fluid.
From:
brickintheyard
Views:
3087
5
ratings [...]
|
|
Makeup FX Cut made with Gel-10
Makeup FX Cut made with Gel-10
Simple gash made with Gel-10 silicone cut kit.
From:
brickintheyard
Views:
21149
57
ratings [...]
|
|
Mold Making: Clay Pour into Gel-10 Mold
Mold Making: Clay Pour into Gel-10 Mold
Here's the clay pour mentioned in the Gel-10 lifecast video. This was done with TexClay since it has a relatively low melting temp. And has a good viscosity @ 200 degrees F for sloshing. [...]
|
|
Makeup FX: Gel-10 Horror Makeup
Makeup FX: Gel-10 Horror Makeup
I posted this makeup job a while back but I have re-edited it with new audio. I did this with Platsil Gel-10 and no blending makeup. This is a great way to create "out of the kit" [...]
|
|
Mold Making: Platsil Gel-10 Lifecast
Mold Making: Platsil Gel-10 Lifecast
Full head cast done with Platsil Gel-10. This is merely an overview of the process. I skip over some of the basic steps that are the same with alginate. This is a fairly ambitious process so start [...]
|
|
Mold Making: Gel-10 1 Piece Mold
Mold Making: Gel-10 1 Piece Mold
Quick overview of mold process using Gel-10 silicone. This is a great method for fast, inexpensive, molds. I use this method a lot when a quick mold is needed on site. The required materials are Gel-10, [...]
|
